Publicité
Les langues disponibles
Les langues disponibles
EnglisH
6
introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from the support that
Philips offers, register your product at www.philips.com/welcome.
general description (Fig. 1)
a Motor unit
B Control knob with pulse setting and speed settings
C Blender blade unit
D Sealing ring of blender
E Plastic blender jar
F Level indication
g Lid of blender jar
H Opening in lid
i
Fruit filter
J
Measuring cup
K Dry mill beaker
l Wet mill beaker
M Sealing ring of wet mill
n Wet mill blade unit
important
Read this user manual carefully before you use the appliance and save it for future reference.
general
Danger
-
Never immerse the motor unit in water or any other liquid, nor rinse it under the tap. Use only
a moist cloth to clean the motor unit.
Warning
-
Check if the voltage indicated on the appliance corresponds to the local mains voltage before
you connect the appliance.
-
Do not use the appliance if the plug, the mains cord or other parts are damaged.
-
If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by
Philips or similarly qualified persons in order to avoid a hazard.
-
Never use the blender jar, the dry mill beaker or the wet mill beaker to switch the blender on
and off.
-
Never let the blender run unattended.
-
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their
safety.
-
Children should be supervised to ensure that they do not play with the appliance.
-
Do not touch the blades, especially when the blender is plugged in. The blades are very sharp.
-
If the blades get stuck, unplug the blender before you remove the ingredients that block the
blades.
-
Make sure the blade unit is securely fastened to the blender jar or mill beaker before you
assemble the blender jar or mill beaker onto the motor unit.
Caution
-
Always unplug the blender before you assemble, disassemble or make adjustments to the
blender jar, the dry mill or the wet mill and before you start to clean the blender.
All manuals and user guides at all-guides.com
Publicité
