The Settings Screen; Flexible Massage - Balboa VL600S Manuel D'utilisation

HOW TO USE YOUR SPA

3.3.3. THE SETTINGS SCREEN

Programming
The Settings Screen is where all programming and other spa behaviors are controlled. Each icon
on the Settings screen takes you to a different screen, where one or more setting may be viewed
and/or edited.
The Heat Icon
Range.
Dual Temperature Ranges (High vs. Low)
This system incorporates two temperature range settings with independent set temperatures. The
specific range can be selected on the Settings screen and is visible on the Main Screen in the upper
left corner of the display.
These ranges can be used for various reasons, with a common use being a "ready to use" setting
vs. a "vacation" setting.
Each range maintains its own set temperature as programmed by the user. This way, when a
range is chosen, the spa will heat to the set temperature associated with that range.
High Range can be set between 80°F and 104°F/ 27 ºC and 40 ºC.
Low Range can be set between 50°F and 99°F / 10 ºC and 37 ºC.
Freeze Protection is active in either range.
Heat Mode – Ready vs. Rest
In order for the spa to heat, a pump needs to circulate water through the heater. The pump that
performs this function is known as the "heater pump".
The heater pump can be either a 2-speed pump (Pump 1) or a circulation pump.
If the heater pump is a 2-Speed Pump 1, Ready Mode will circulate water every 1/2 hour, using
Pump 1 Low, in order to maintain a constant water temperature, heat as needed, and refresh the
temperature display. This is known as "polling".
Rest Mode will only allow heating during programmed filter cycles. Since polling does not occur,
16 Spa for private use - Operating instructions
takes you to a screen where you control the Heat Mode and the Temperature