Control System For Tp800; Start Up; The Main Screen; The Seetings Screen - Balboa TP600 Manuel D'utilisation

HOW TO USE YOUR SPA
The Meaning of Filter Cycles
1. The heating pump always runs during the filter cycle*
2. In Rest Mode, heating only occurs during the filter cycle
3. Purges happen at the start of each filter cycle
* For example, if your spa is set up for 24/hour circulation except for shutting off when the water temperature is
3˚F/1.3˚C above the set temperature, that shutoff does not occur during filter cycles.

5.4. CONTROL SYSTEM FOR TP800

(This section is only for spas equipped with this control system)
5.4.1. START-UP
Fill the spa to its correct operating level. Be sure to open all valves and jets in the plumbing system
before filling to allow as much air as possible to escape from the plumbing and the control system
during the filling process.
After turning the power on at the main power panel, the top-side panel will display a splash screen
or startup screen.

5.4.2. THE MAIN SCREEN

ICON Specifications
5.4.3. THE SETTINGS SCREEN
Programming, Etc.
The Settings Screen is where all programming and other spa behaviors are controlled. This screen
has several features that can be acted on directly. These features include Temp Range, Heat Mode,
and Invert Panel. When one of these items is highlighted, the Select Button is used to toggle
between two settings. All other menu items (with an arrow pointing to the right) go to another
level in the menu.
22 Compact Kit for private use - Operating Instructions