Balboa VL600S Manuel D'utilisation page 17

HOW TO USE YOUR SPA ENG
the temperature display may not show a current temperature until the heater pump has been
running for a minute or two.
When the heater pump has come on automatically (for example for heating) you can switch
between low speed and high speed but you cannot turn the heater pump off.
Circulation Mode
If the spa is configured for 24HR circulation, the heater pump generally runs continuously. Since
the heater pump is always running, the spa will maintain set temperature and heat as needed in
Ready Mode, without polling.
In Rest Mode, the spa will only heat to set temperature during programmed filter times, even
though the water is being filtered constantly when in 24HR circulation mode.
Ready-in-Rest Mode
Ready in Rest Mode appears in the display if the spa is in Rest Mode and the Jets 1 Button is
pressed. When the heater pump has come on automatically (for example for heating) you can
switch between low speed and high speed but you cannot turn the heater pump off. After 1 hour,
the System will revert to Rest Mode. This mode can also be reset by selecting the Heat Mode line
on the Screen shown here.
ADJUSTING FILTRATION
Main Filtration
Using the same adjustment as Setting the Time, Filter Cycles are set using a start time and a
duration. Each setting can be adjusted in 15-minute increments. The panel calculates the end time
and displays it automatically.
The Filter Icon on the Settings Screen takes you to a screen where you control the Filter
Cycles.
Filter Cycle 2 - Optional Filtration
Filter Cycle 2 is OFF by default. Press "1" to view Filter 1. Press "2" once to view Filter 2. Press "2"
again to turn Filter 2 ON or OFF. When Filter Cycle 2 is ON, it can be adjusted in the same manner
as Filter Cycle 1. It is possible to overlap Filter Cycle 1 and Filter Cycle 2, which will shorten overall
filtration by the overlap amount.
Circulation Pump Modes
Some spas may be manufactured with Circ Pump settings that allow programming filtration
cycle duration. Some circ Modes are pre-programmed to operate 24 hours a day and are not
programmable. Refer to the spa manufacturer's documentation for any Circ Mode details.
Purge Cycles
In order to maintain sanitary conditions, as well as protect against freezing, secondary water
devices will purge water from their respective plumbing by running briefly at the beginning of
each filter cycle. (Some systems will run a certain number of purge cycles per day, independent of
the number of filter cycles per day. In this case, the purge cycles may not coincide with the start
of the filter cycle.)
If the Filter Cycle 1 duration is set for 24 hours, enabling Filter Cycle 2 will initiate a purge when
Filter Cycle 2 is programmed to begin.
17