Programmable Wifi Touch Panel; Start-Up; The Main Screen - Balboa VL600S Manuel D'utilisation

HOW TO USE YOUR SPA

3.3. PROGRAMMABLE WIFI TOUCH PANEL

(This section is only for spas equipped with this control system)

3.3.1. START-UP

Fill the spa to its correct operating level. Be sure to open all valves and jets in the plumbing system
before filling to allow as much air as possible to escape from the plumbing and the control system
during the filling process.
After turning the power on at the main power panel, the top-side panel will display a splash screen
or startup screen.

3.3.2. THE MAIN SCREEN

ICON Specifications
1. = High Temperature Range.
2. = Ready Mode.
3.
= Filter1 Mode.
4.
=Water Care (Ozone or UV, depending the system installed) is Running. If you don't see
the icon that means the Disinfection (Ozone or UV) is OFF
5.
= Cleanup Cycle is Running. Note: Not all systems that can run a Cleanup Cycle display
this icon.
6.
= Wi-Fi icon just indicates that the Wi-Fi link is connected. It does not indicate signal
strength. Note: Not all systems that support Wi-Fi display this icon.
7. Lock Icon: When displayed, indicates the panel is in a locked mode. To unlock or lock a setting
or panel lock, first press the corresponding icon on the Lock Screen then press the word "Lock"
for 5+ seconds until the text and icon change to the opposite state.
There are 2 lock icons that can be shown on the title bar of most screens.
A tall skinny one
affected by the settings lock.
And the standard lock icon
panel are locked, only the panel lock will show since the settings lock doesn't do much in that
situation. When the panel is locked, the Settings Screen will only show items not affected by that
lock (System Info and Lock Screens).
14 Spa for private use - Operating instructions
= Low Temperature Range.
= Ready And Rest Mode.
= Filter2 Mode.
representing a settings lock is applied. It is shown on screens that are
which represents the Panel being locked. If both settings and
= Rest Mode.
= Filter1 and 2 Mode.