Maintenance Of The Light - Balboa VL600S Manuel D'utilisation

MAINTENANCE INSTRUCTIONS OF THE SPA

4.4. MAINTENANCE OF THE LIGHT

Replacing the lamp is the only required maintenance on the spotlight. To replace the lamp, follow
these steps:
WARNING! - RISK OF ELECTRIC SHOCK
Make sure the power of the Spa is turned off.
The new lamp must have the same features as the lamp supplied.
Never install lamps without the front lens.
To ensure perfect watertightness, clean the mounting base of the flat gasket
of the glass or replace it if you observe any dents or permanent damage.
Depending on spotlight model, the lamp is replaced in the following way:
Without draining the Spa (depending on the model of spotlight) :
• Dismantle the wooden side panel where the spotlight is installed using a medium-sized stecker
screwdriver.
• To replace the lamp, turn the lamp-holder bushing anticlockwise and lift it from its position.
• Once the faulty lamp has been replaced, place the lamp-holder back in position and reassemble
the wooden side panel of the Spa.
• If you have any doubt about the explanation of this operation, contact your authorised dealer or
authorised technical service.
30 Spa for private use - Operating instructions