Control Of The Swimspa; Anti-Freeze Protection - Balboa VL600S Manuel D'utilisation

HOW TO USE YOUR SPA

3.6. CONTROL OF THE SWIMSPA

A - Jetstream control
With the jetstream control you can choose the power of the bottom jetstream and the massage.
B – Fountains control
Turning the fountains control you can regulate the flow of the three fountain jets. The fountain
only runs when the filtration circuit is running or the spa is in heating process.
C – Main control panel
With the electronic main control panel you can turn on or turn off the Jets, Blower (optional)
and Light, set the Temperature, the filtration cycles and Time.
D – Air control
With the air input valve you can adjust the air turbulence of the jetstream.
E – Jetstream control
With the jetstream control you can choose the power of the top jetstream and the massage.

3.7. ANTI-FREEZE PROTECTION

If the temperature sensors detect a drop in temperature to below 6.7ºC, the heating element and
filter pump will connect automatically to prevent the water from freezing and the damage this
could cause the Spa.
The equipment will remain connected for 4 minutes after the temperature reaches 7.2ºC.
In colder climates, an additional temperature sensor can be added as a precaution and to avoid
freezing conditions not detected by the standard sensor.
If the pump turns off in this situation, empty the Spa and contact your authorised dealer or
Technical Assistance Service.
24 Spa for private use - Operating instructions