Flexible Massage - Balboa VL600S Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 73
HOW TO USE YOUR SPA
ENG

3.4. FLEXIBLE MASSAGE

Press the button on the main panel to turn on the pump that supplies water to the sequencing
valves. When the pump is energized the Therapy Sequencer will also be powered up and will open
all of the valves.
The LCD on the Therapy Sequencer top side panel will momentarily display "0" and then it will
display two dashes. This means that the system has been energized and all valves have been
opened, but the system has not been "turned on" to enable sequencing.
Push the On/Off button one time. This will change the LCD to indicate "On". The system has been
activated for sequencing but no change in operation will occur.
To start a sequencing program, push the "Program" button one time. The LCD will momentarily
display "P2" and then alternately display "P2" with "S1". The system is now running program 2
and sequencing at speed 1. (Speed 1 is the default sequencing speed).
To change programs, push the "Program" button to step through the programs. The LCD will
momentarily display the next selected program "P3", "P4", "P5" etc. and then alternately display
the selected program with the sequencing speed "S1" as shown above.
To change the sequencing speed, push the "Speed" button once. The LCD will momentarily display
the next selected sequencing speed, "S1", "S2", or "S3", and then alternately display the current
program and the sequencing speed.
To pause at any point in the therapy sequence, push the "Pause" button. This will hold the
sequencer in the current mode until the "Pause" button is pushed again to resume the sequence.
The LCD will momentarily display "PA" and then alternately display "PA" and the current program
number.
21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Vl700s

Table des Matières