Scheppach MRS1300 Traduction Des Instructions D'origine page 30

15. Troubleshooting
Fault
Motor does not work
The engine runs slowly
and does not reach the
operating speed.
Motor makes excessive
noise
The motor does not reach
its full power.
Motor overheats easily.
30 | GB
Possible cause
Motor, cable or plug defective,
fuses burnt
Voltage too low, coils damaged,
capacitor burnt
Coils damaged, motor defective
Circuits in the network are over-
loaded (lamps, other motors, etc.)
Overloading of the motor, insuffi-
cient cooling of the motor
www.scheppach.com
Remedy
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger! Check
fuses and replace if necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist. Arrange for replacement of the capacitor by
a specialist
Arrange for inspection of the motor by a spe-
cialist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor, remove dust from
the motor in order to ensure optimal cooling of
the motor