Publicité
Les langues disponibles
Les langues disponibles
g)
If devices are provided for the connection of
dust extraction and collection facilities, en-
sure these are connected and properly used.
Use of dust collection can reduce dust-related
hazards.
h)
Do not let familiarity gained from frequent use
of tools allow you to become complacent and
ignore tool safety principles. A careless action
can cause severe injury within a fraction of a sec-
ond.
4.
Power tool use and care
a)
Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at the
rate for which it was designed.
b)
Do not use the power tool if the switch does
not turn it on and off. Any power tool that can-
not be controlled with the switch is dangerous and
must be repaired.
c)
Disconnect the plug from the power source
and/or remove the battery pack, if detachable,
from the power tool before making any adjust-
ments, changing accessories, or storing pow-
er tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d)
Store idle power tools out of the reach of chil-
dren and do not allow persons unfamiliar with
the power tool or these instructions to operate
the power tool. Power tools are dangerous in the
hands of untrained users.
e)
Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition that
may affect the power tool's operation. If dam-
aged, have the power tool repaired before use.
Many accidents are caused by poorly maintained
power tools.
f)
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g)
Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from those intended
could result in a hazardous situation.
h)
Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unexpected
situations.
5.
Service
a.) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
Safety instructions for all applications
Common safety instructions for grinding, working
with wire brushes, polishing:
a)
This electric tool is to be used as a grinder,
wire brush, polishing. Read all safety warn-
ings, instructions, illustrations and data that
are received with the device. Failure to observe
all the following instructions may result in electric
shock, fire and / or serious injury.
b)
This electric tool is not suitable for hole cut-
ting and cut-off grinding. Operations for which
the power tool was not designed may create a haz-
ard and cause personal injury.
c)
Do not use a tool attachment that has not been
specifically envisaged and recommended by
the manufacturer for this electric tool. Just
because the accessory can be attached to your
power tool, it does not assure safe operation.
d)
The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool. Tool attachment that rotate faster
than permitted can break and fly off at high speed.
The outside diameter and the thickness of your
e)
accessory must be within the capacity rating
of your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
f)
Insert tools with threaded inserts must fit ex-
actly on the thread of the grinding spindle.
For insert tools that are mounted by means of
a flange, the hole diameter of the insert tool
must match the mounting diameter of the
flange. Insert tools which are not precisely at-
tached to the electric tool rotate unevenly, vibrate
very strongly and can cause a loss of control.
www.scheppach.com
GB | 23
Publicité
