Panasonic CF-72 Serie Mode D'emploi page 16

First-time Operation
2
1
Power Indicator
Power Switch
16
5
Open the display
To open the display, slide the latch located at the front and lift open the display.
6
Turn your computer on
Slide the power switch toward the rear of the computer and hold it for approximately one
second until the power indicator turns on before releasing it.
CAUTION
Do not slide the power switch repeatedly.
Once the computer is powered off, you must wait at least ten seconds before pow-
ering it on again.
NOTE
The power saving function is factory set, so if there is no input from a key, the touch
pad or an external mouse (when one is connected) for a certain interval of time, the
power to the LCD and hard disk may be turned off. The LCD will resume operation
when the touch pad or an external mouse (when one is connected) is used or a key is
pressed.
The power to the LCD may be turned off while Windows is setting up or even when an
application software is being installed. In this case, because it is conceivable that a
selection dialog box will be shown, do not press Space or Enter to attempt to
resume from this condition as doing so may trigger a selection, but instead, press a key
unrelated to the direct triggering of a selection, like Ctrl .
Windows 98 Windows 2000
In addition, when the computer is left alone, it automatically enters the standby* mode
( "Standby/Hibernation Functions"). The computer will resume by sliding
the power switch.
* Windows 2000: standby or hibernation
7
Setup Windows
Moving the cursor ( ) or clicking buttons can be performed with the touch pad (
20).
Windows 98 WindowsNT
1 Follow the on-screen instructions.
Windows 2000
page