Publicité
Les langues disponibles
Les langues disponibles
First-time Operation
Latch
2
Cover
3
Label-side down
4
Mark
Read the steps below to help you learn what parts are included, and to gain an understanding of
some basic computer-related operations.
1
Write down the Product Key or Product ID
Write down the number shown on the "Certificate of Authenticity" located on the
bottom of the computer.
2
Read the LIMITED USE LICENSE AGREEMENT
Before removing the seal covering the power switch, read the LIMITED USE LICENSE
AGREEMENT.
3
Insert the battery pack
Turn your computer over.
1
Slide the latch, and then without releasing it, slide and remove the battery pack
2
cover.
Insert the battery pack into the computer with the label-side down.
3
CAUTION
Be sure the battery pack is properly connected to the connector.
Do not allow the battery connector to touch any portion of the computer.
The computer may not operate properly.
4
Match the mark on the battery pack cover to the mark on the computer and slide the
cover back into place.
CAUTION
If the cover is not attached properly, the battery may fall out while the computer is
being carried.
4
Connect your computer to a power outlet
CAUTION
Be sure the AC adaptor is connected until completing step 7 on page 16.
Handling the AC adaptor
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adaptor with your computer. Using an AC adaptor other
than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord from
your AC wall outlet.
Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible power
source (UPS) is highly recommended unless the battery pack is installed.
(
page 8)
15
Publicité
