Lux Tools 115212 Instructions D'utilisation D'origine page 55

All manuals and user guides at all-guides.com
115212_115213_Trimmer_Benzin.book Seite 55 Mittwoch, 8. Juni 2016 12:23 12
Type of pro- Minimum
tection: protection
Head protec- Helmet
tion
Hearing pro- Ear plugs
tection
Eye protection Completely
closed gog-
gles
Hand guard Working gloves made of leather
Protection for High safety shoes with a
feet gripped sole, steel toe caps and
leg protection
Clothing Safety dungarees (cut-proof)
Jacket with
long sleeves
made from
sturdy fabric
Cutting tips
WARNING! Risk of injury! When using
the product, uncontrolled kickback may
occur. In the event of uncontrolled
kickback , the product is pushed away/
accelerated with high energy. Observe
the described notes regarding cutting.
Never cut material, solid material in
particular (e. g. scrub, bushes etc.) in an
area in which kickback of the product is
possible.
• Only cut with the right (shown here as dark
Ideal
grey) area of the cutting unit by moving the
product in a semi-circle from left to right. Only
this area offers light and low kickback cutting.
Helmet with
• Never start cutting in the left (light grey) area.
visor
This represents a high level of kickback risk and
Circumaural
objects may be thrown in your direction by the
ear defenders
rotation of the cutting tool. You may be hurt as a
DIN EN 352-1
result.
• If you move the product from right to left, you
Visor on hel-
must keep the cutting tool away from the
met
ground to ensure that nothing is thrown up.
• Cut long grasses from top to bottom to
ensure that the grasses do not get tangled
around the cutting tool.
Cut in a sensitive manner:
• Only use the tip of the cutting tool. This is gen-
tle on the cutting tool and prevents grass getting
caught in the tool.
• Only take the cutting tool as close as abso-
Safety jacket
lutely necessary to posts, walls, fences and
(cut-proof)
similar. Solid objects will wear the cutting tool
down quickly and may damage it.
• Tree trunks, young trees and bushes may be
damaged by the cutting tool.
Product overview
Figure 1 – Page 3
1. Motor
2. Eye for strap
3. Operating bar
4. Upper shaft pipe
5. Locking wheel
6. Lower shaft pipe
7. Blade head
8. Blade
9. Protective hood
10. Protective hood for thread spool
11. Spool housing
12. Operating handle
Figure 2 – Page 4
13. Ignition cable with spark plug
14. Cold start lever
15. Air filter housing
16. Locking mechanism for air filter housing
17. Fuel pump
18. Tank lid
19. Fuel tank
20. Starter cord
21. Exhaust silencer
GB
(Choke)
55