Lamborghini Caloreclima EASY TECH D F Instructions D'utilisation, D'installation Et D'entretien page 52

Connection with separate pipes
C
fig. 14 - Examples of connection with separate pipes (
Table 5- Typology
Type Description
C1X Wall horizontal exhaust and intake. The inlet/outlet terminals must be concentric or close enough to be subjected to similar wind
conditions (within 50cm)
C3X Roof vertical exhaust and intake. Inlet/outlet terminals like for C12
C5X Separate wall or roof intake and exhaust and in any case in areas with different pressures. The exhaust and intake must not be
located on opposite walls
C6X Intake and exhaust with separately certified pipes (EN 1856/1)
B2X Intake from installation room and wall or roof exhaust
IMPORTANT- THE ROOM MUST BE PROVIDED WITH APPROPRIATE VENTILATION
For the connection of separate ducts, fit the unit with the following starting accessory:
010011X0
Before installation, check the baffle to use and make sure the maximum permissible length has not been exceeded, by
means of a simple calculation:
1.Establish the layout of the system of split flues, including accessories and outlet terminals.
2.Consult table 7 and identify the losses in m
3.Check that the sum total of losses is less than or equal to the maximum permissible length in table 6.
Table 6- Baffles for separate ducts
Max. permissible length
Baffle to use
52
5x
fig. 15 - Starting accessory for separate ducts
(equivalent m) of every component, according to the installation position.
eq
EASY TECH D F24
60 m
eq
0 - 20 m Ø 43
eq
20 - 45 m Ø 47
eq
45 - 60 m No baffle
eq
cod. 3542B960 - Rev. 01 - 04/2023
B
2x
= Air /
80
EASY TECH D F32
48 m
eq
0 - 15 m
eq
15 - 35 m
eq
35 - 48 m No baffle
eq
EASY TECH D F
C
1x
= Fumes)
80
EASY TECH D F37
40 m
eq
Ø 45 0 - 10 m
eq
Ø 50 10 - 20 m
eq
20 - 30 m
eq
30 - 40 m
eq
Ø 47
Ø 50
Ø 52
No baffle
EN