Publicité
Les langues disponibles
Les langues disponibles
Operation
Figure 27
Indicator Lights
IN USE
This light will remain on while washer is in
use.
RINSE
This light will be on during the rinse portion
of the cycle.
SPIN
This light will be on during the rinse/final
spin only. Washer will stop automatically at
end of cycle. (SPIN and IN USE lights will
go out indicating end of cycle.) Leave lid
open after removing laundry.
IMPORTANT: If washer fails to operate properly after
installation, make sure electrical service and water
supply faucets are turned on. Are all the controls prop-
erly set? Have a qualified service person refer to the
wiring diagram (located inside of washer control hood),
check for broken, loose or incorrect wiring.
Should washer stop, but IN USE, RINSE or SPIN light remain
on, the motor overload protector may have cycled. Refer to Main-
tenance section.
To reduce the risk of bodily injury, do not remove
laundry from washer until all lights are out, and all
moving parts have stopped.
The washer will stop (pause) shortly before the first spin.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
All manuals and user guides at all-guides.com
TLW2048N_SVG
WARNING
Control Modes
Power-Up Mode
The control enters this mode after power is applied to the washer.
In Power-Up Mode, the control will detect the state it was in at
power-down to determine what mode to enter. After the control
completes operation in the Power-Up Mode, it will enter either
the Ready, Test or Run Modes.
Ready Mode
In Ready Mode, the control will wait for the vend to be satisfied
before entering Run Mode.
Run Mode
In Run Mode, the control is running a cycle. The IN USE LED
will be lit. For metered models, any time the control receives a
coin slide pulse during a cycle, the IN USE LED will flash brief-
ly to indicate the coin input. For nonmetered models, any time
the control receives a pulse from the push-to-start switch during a
cycle, the IN USE LED will flash briefly to indicate the push-to-
start input.
Lid Open Mode
The control enters Lid Open Mode when the lid is opened during
Run Mode. All cycle activity is stopped. The cycle time count
down stops unless the lid is opened during the last three minutes
of the final spin step. In this case the time will continue to count
down.
End of Cycle Mode
The control enters End of Cycle Mode when a cycle is complete.
The IN USE LED will be off. The control will remain in this
mode until the lid is opened or vend has been satisfied.
Error Mode
In Error Mode, the IN USE LED flashes to display fill and drain
errors (refer to paragraphs below). Error Mode can only be exited
by powering down washer. The Error Mode can be turned off by
setting dipswitch 2 to the CLOSED position. Refer to Table 1 .
Fill Error
A Fill Error will occur if the tub does not fill within 62 minutes
of the start of the cycle. A Fill Error is indicated by the control
W092
flashing the IN USE LED twice separated by a one and a half
second pause until the control is powered down. If Error Mode is
turned off (refer to Table 1 ), the fill error will not occur and the
control will continue to wait for the fill level to be reached.
Drain Error
A Drain Error will occur if the tub is not empty after a spin cycle.
A Drain Error is indicated by the control flashing the IN USE
22
Part No. 202630R2
Publicité
