Publicité
Les langues disponibles
Les langues disponibles
•
Bit (No. 12 screws) Part No. 282P4
•
Control panel tamper-resistant screw Part No. 35528
•
Front panel tamper-resistant screw Part No. 35527
The following list is the procedure required to install the Phillips
head screw and tamper-resistant screws:
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.
To reduce the risk of electric shock, fire, explosion,
serious injury or death:
•
Disconnect electric power to the washer before
servicing.
•
Never start the washer with any guards/panels re-
moved.
•
Whenever earth/ground wires are removed during
servicing, these earth/ground wires must be re-
connected to ensure that the washer is properly
connected to a protective earth/ground.
1. Remove the Phillips head screw from service door (refer to
Figure 19 ).
2. Remove two screws holding control panel to control hood.
3. Tilt control panel forward and lay on a protective pad to pre-
vent scratching of cabinet top.
4. Insert Phillips head screw down through double "D" hole in
left rear corner of cabinet top (inside control hood) until it en-
gages retainer nut located on left rear corner gusset of cabinet.
5. Finger tighten screw.
IMPORTANT: Do not use a power driver to tighten
screw. Torque of a power driver could over-tighten
screw causing damage to cabinet assembly.
6. Secure control panel to control hood using two No. 8 tamper-
resistant screws, Part No. 35528.
7. Remove two screws holding front panel to base of washer and
install two No. 12 tamper-resistant screws, Part No. 35527.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
All manuals and user guides at all-guides.com
WARNING
WARNING
1
W299
3
W883
1. 35528 No. 8 Screws
2. Double "D" Hole
3. 35527 No. 12 Screws
19
2
TLW2102N_SVG
Figure 19
Part No. 202630R2
Installation
Publicité
