Publicité
Les langues disponibles
Les langues disponibles
2. Run washer through one complete cycle to make sure it is op-
erating properly.
Vending
Meter Case
The factory mounted coin meter case does not include the service
door lock, coin slide (if applicable), coin drawer, coin drawer
lock or keys. These parts must be ordered (at extra cost) accord-
ing to the purchaser's requirements direct from the manufacturer
of your choice.
NOTE: You have the option of using a screw type lock
or a 1/4 turn lock on the meter case service door. If you
choose to use a screw lock, then the special bracket
(located inside the meter case) must be used. DO NOT
use the special bracket if a 1/4 turn lock is used.
Coin Drawer Security - For additional security, drill out the two
pilot holes on each side of the front of the meter case to 6.4 or 7.9
mm [1/4 or 5/16 inch] holes and install a bicycle lock through
these holes.
NOTE: An 203 mm [8 in.] coin drawer is required for
coin operated electronic control models.
Slide Extension Assembly
1. Remove slide extension parts from parts accessories bag in-
cluded in unit.
2. Install extension lever with arm that has one star facing down.
Refer to Figure 13 .
1. One Star
3. Install extension lever with rounded corner facing away from
extension bracket using shoulder bolt, flat washer and nut.
Refer to Figure 14 .
4. Install spring to extension bracket with hook facing down. In-
stall other end of spring to extension lever with hook facing
left while standing in front of unit. Refer to Figure 14 .
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
All manuals and user guides at all-guides.com
1
TLW2160N_SVG
Figure 13
2
1
7
6
1. Shoulder Bolt
2. Spring
3. Flat Washer
4. Rounded Corner
5. Nut
6. Extension Lever
7. Extension Bracket
5. Install extension bracket and lever assembly onto coin slide
bracket using two screws and locknuts. Refer to Figure 15 .
IMPORTANT: Install coin slide bracket with side
marked "A" facing up and toward extension bracket
and lever assembly. Refer to Figure 15 .
1
1. Spring Installed
2. Extension Bracket and Lever Assembly
3. Coin Slide Bracket - Letter "A"
17
Installation
3
4
5
TLW1610K_SVG
Figure 14
2
3
TLW2163N_SVG
Figure 15
Part No. 202630R2
Publicité
