Tunturi Platinum Cross sprinter Mode D'emploi page 5

Step 2: Moving handlebars & pedals
1. Slide the two moving handlebars (9 &10) onto the
upright tube axle. There is a left and right handlebar
so make sure you assemble the correct one on each
side. Do not force the handlebars onto the axle or use
a hammer as damage to the bearings could occur.
The moving handlebars have been previously instal-
led at the factory and should fit properly, although it
is a snug fit.
2. Secure the handlebars in place with the M10 x
20mm stainless steel bolts (49) and cup washers (27)
and tighten. Snap the endcaps (74) over the cup
washers.
3. Connect the clear drain hoses and install the foot
pedals (76 left, 77 right) with twelve M5 x 10mm
2.
All manuals and user guides at all-guides.com
Cross sprinter
5