Use - Vermeiren DX2 Mode D'emploi

OPERATOR CONTROL DX2

1. Use

The operator control built into your electric wheelchair enables you to control all the driving,
steering, braking and operating processes and to control other adjusting motors (lifting
column, seat and back adjuster). The wheelchair's electrical unit and electronics are
constantly being monitored internally. Any fault in the electronics is indicated on the
operating display (6) and the status display (1) and, if necessary, the wheelchair may be
switched off for reasons of safety (see the chapter on fault analysis).
Vermeiren is responsible for the changes in the software. For changes in the software
contact Vermeiren.
The DX2 system is available in two different operator controls (DX2 Basic; DX2 with LCD
screen) which have some different operating buttons.
2
1
10
3
4
5
6
8
14
16
17
DX2 Basic:
Without LCD
screen
2
3
7
1
10
8
5
With LCD screen
1 = "ON / OFF" button
2 = Battery charge
indicator
3 = Speed switch
"-" : slower
"+" : faster
11
4 = Speed indicator
5 = "Horn" button
7
6 = Light sensor*
9
7 = Lock Led
12
8 = Left indicator
13
9 = Right indicator
15
18
* The light sensor dims the display when it is dark
4
6
9
3
10 = Left indicator LED
11 = Right indicator LED
12 = Adjustment Actuator LEDs
13 = Adjustment Actuator
selection
"-": down
"+": up
14 = Warning indicator
15 = Lights
16 = Attendant profile LED
17 = Fault indicator LED
18 = LED side lights
1 = Display
2 = "ON / OFF" button
3 = "Left indicator" + "Light" button
4 = "Right indicator" + "Warning
indicator" button
5 = "Horn" button
6 = Fault code/operating display
7 = Brightness sensor
8 = "Drive profile" button
9 = "Select field" button
10 = Max speed reduction
DX2 Operator control
vD - 2013-04