Use - Vermeiren operator control Shark Mode D'emploi

OPERATOR CONTROL SHARK

1. Use

The operator control built into your electric wheelchair enables you to control all the driving, steering,
braking and operating processes and to control other adjusting motors (lifting column, seat and back
adjuster). The wheelchair's electrical unit and electronics are constantly being monitored internally.
Any fault in the electronics is indicated on the operator control and, if necessary, the wheelchair may
be switched off for reasons of safety (see the "Error codes" section).
Vermeiren is responsible for the changes in the software. For changes in the software contact
Vermeiren.
The Shark system is available in three different operator controls which have some different operating
buttons.
2
7
3
Operator control type 1
13
11
Operator control type 3
12
1
5
4
6
8
9
11
Operator control type 2
1 = On/Off button
2 = Battery charge indicator
3 = Reduce speed ("Tortoise" symbol)
4 = Increase speed ("Hare" symbol)
5 = Speed indicator
6 = Attendant control unit
7 = Horn
8 = Service indicator (fault analysis)
12
9 = Left indicator light
10 = Right indicator light
11 = Hazard warning lights
12 = Lights
13 = Electrical adjuster for seat/back
2
Shark Operator control
vA - 2011-07
10