Set Time - Vermeiren DX2 Mode D'emploi

In
Adjust function
Display
Seat inclination
Angle of backrest
Leg support left
Leg support right
Leg supports
simultaneous
Lift column

Set time

By default, the factory sets the time to be visible in the status display. To change this option, proceed
as follows:
Display
Menu
L
The only functions displayed in the menu selection and
the centre of the display are those which exist on your
wheelchair and have been enabled.
For your safety the adjust functions can only be
activated when all four wheels of the wheelchair are
standing still. The driver programs are disabled
while the adjust functions are active.
Select the program function using the field
selection button (9) and the display will show the
menu for the special functions.
Select left/right with the joystick or the menu
selection button (10) until the time function you
want appears in the centre of the display.
If you want to set the time, confirm by moving the
joystick upwards.
The time digit waiting to be set flashes. To change
other digits, you can select left/right with the
joystick or use the menu selection button (10).
To adjust the digits, select upwards with the
joystick.
To save the new time, confirm by moving the
joystick downwards.
To switch back to the driving program, select the
drive profile button (8) in drive mode.
13
CAUTION: Risk of injury or damage Make
sure that no objects and/or persons are
inside the swinging range of the adjust
functions, since this could cause damage
and/or injury.
DX2 Operator control
vD - 2013-04