Télécharger Imprimer la page

Casada braintronics ALPHASONIC II Mode D'emploi page 18

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
Starting up
1 – ATTACHING THE SIDE PARTS
a) First locate the connector and the air hose, which can be found on the side of the seat
part (Illustration 1).
b) After feeding the connector and the air hose through the metal device, link each connec-
tion with its counterpart on the armrest. Please ensure when plugging in the cables that
you always plug in the same colours together! (Illustration 2 & Illustration 3).
Illustration 1
c) Once you have joined the connections together, wrap the connections in the dust cover
that is attached to the armrest under the connections. Feed the protruding cables back
into the seat part. Be careful that the plug-in connectors and the air hose do not bend or
jam. (Illustration 4)
Illustration 3
d) Position the rear of the side part so that it overlaps with the holes on the seat and
secure it using the 2 screws that are included in the delivery. (Illustration 5)
e) Then take the decorative screen and clip it into the slot above the screws. Please note
that the screens are marked with left and right on the inside. (Illustration 6)
Illustration 5
34
Illustration 2
H0
H1
H2
H3
Illustration 4
H4
Bac k St retc h
Bac k St retc h
Illustration 6
Starting up
Now secure both side parts to the front of the seat. Two screws are required for this on
both sides. Position the mounting bracket of the side part with the two holes towards the
front of the seat part, overlapping with the mounting piece and tighten the screws firmly.
Ensure that the hook on the side part is hooked onto the connecting piece of the seat part
before tightening the screws (Illustration 7, Illustration 8 & Illustration 9).
Illustration 7
Illustration 9
H0
H1
Repeat these steps on the other side.
H2
H3
H4
2 – ATTACHING THE FOOTREST
a) First attach the rotating shaft to the fixed axle. Ensure that the R-bolts are the correct way
round (Illustration 1).
b) Once the fixed axle is aligned and combined (Illustration 2), join the pieces together.
Illustration 1
Illustration 8
Illustration 2
35

Publicité

loading