Publicité
Les langues disponibles
Les langues disponibles
3 Product Assembly
Base assembly
•
Loosen the screw from the bottom of the outer tube (14).
•
Place the inner tube (12) with the tube support onto the stand cover (15) and fix it with the
screw (16).
•
Attach the motor with the switch compartment to the inner pipe. Ensure the switch compart-
ment is pushed fully onto the inner tube and secured with the screw provided.
Assembly of the blade and grille
•
Unscrew the plastic mounting nut from the front of the motor housing by rotating it anti-
clockwise.
•
Position the rear grille against the front of the motor housing with the handle on top, ensu-
ring that the locating pegs on the motor housing are engaged correctly in the holes of the
rear grille.
•
Tighten the rear grille mounting nut clockwise. DO NOT OVERTIGHTEN IT.
•
Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the
drive pin that passes through the motor shaft.
•
Tighten the blade cap by turning it anticlockwise.
•
Position the front grille against the rear grille so that the holes in the rims for the small
nut and bolt are in line. Insert the bolt through the holes and screw on the nut. Do not fully
tighten at this stage.
•
Push the grille retaining clips into position and make sure they engage correctly on the rim
of the grille.
•
Fully tighten the small nut and bolt that pass through the rim of the grille
4 Operation of the product
•
Place your fan on a level and dry surface.
•
Plug the fan into a mains socket. Select the desired speed setting.
There are 4 settings – 0 (off), 1 (low), 2 (medium) and 3 (high). The fan can be set to
oscillate by pushing the oscillating knob downwards. To stop oscillation, pull up the
oscillation knob. To adjust the tilt angle of the fan head, swivel the fan to the desired
angle.
•
Caution: The fan should always be switched off when making this adjustment.
37
EN
Publicité
