MINN KOTA MAXXUM Mode D'emploi page 11

Installation of the Hold Down Strap
The Hold Down Strap is not included on all models.
1
a. Before mounting the trolling motor, place the Hold
Down Strap under the Bow-mount between the
Mounting Holes near the back of the motor rest, with
the hook and loop side of the strap facing down.
b. Secure the Bow-mount with the Mounting Bolts
to capture the Hold Down Strap as noted in the
Installation of the Bow-mount Section of this Manual.
c. To secure, stow the motor, and then pull the Hold
Down Strap through the rectangular Ring until snug.
Press the hook pad of the strap, into the loop pad
and secure. The Hold Down Strap should be used
whenever the motor is stowed.
WARNING
When the motor is being transported, on water or land, it is
important to place the motor completely out of water. The
motor should be positioned on the Rails of the Motor Rest.
Release the Depth Collar and slide it along the Shaft until
it contacts the Bowguard, then re-secure the Depth Collar.
For added security during transport secure the Hold Down
Strap. This provides a secure stow and holds the motor in
place during transportation when it is subject to high levels
of shock and vibration. Failure to secure the motor may
result in injury or damage to the unit.
©2020 Johnson Outdoors Marine Electronics, Inc.
1a
Bow-Mount Bow-Mount
Mounting Mounting
Holes Holes
Ring Ring
INSTALLATION
Bow Bow
Hold Down Hold Down
Strap Strap
Hold Down Hold Down
Strap Strap
minnkotamotors.com | 11