Fitting The Electronics Cover - Invacare Aquatec Ocean E-VIP Mode D'emploi

Assembly and installation
Setting the footrest height
1. Pull footrest A up a little.
2. Pull out clip H and reinsert it in the desired position. You may need
to pull the footrest out a little further to do this.
3. Press down the footrest until groove E engages in the pin of the
clip.
4. Adjust the second footrest to the desired height as described.
Removing/attaching the heel straps
1. Open the Velcro® fastener on heel strap D.
2. Remove screw C from the underside of the footplate.
3. Remove the screw and flexible pin with the heel strap.
The heel strap is attached in the reverse order.
!
IMPORTANT
▸ When installing a footrest, make sure that the Velcro®
fastener of the heel strap faces backwards.
Adjusting the heel strap
!
IMPORTANT
▸ Make sure that the Velcro® fastener of the heel strap faces
backwards.
1. Open the Velcro® fastener on heel strap D.
2. Set the heel strap to the desired length.
3. Close the Velcro® fastener again.

4.9 Fitting the electronics cover

1. Turn both footrests outwards or remove them.
2. Use the hand control to move the shower and toilet commode to
the highest position; see Section 5.4 Controlling, lifting.
Shower and Toilet Commode Ocean E-VIP
3. Remove terminal strip A.
4. Fold safety bar B forward.
5. Remove the long connector cable C (180 mm) between the battery
pack and electronics box.
6. Attach short connector cable D (110 mm).
7. Fold the safety bar back again.
8. Reattach the terminal strip.
11