How to Use
EN
Working Modes
The appliance will start in auto mode by default. You can switch to the suction mode or
the Ultra Mode based on your needs.
Auto Mode
While cleaning the floor, the appliance will automatically adjust its suction
power according to different situations.
Ultra Mode
Preparing Ultra Mode, please wait for 30 seconds.
This mode is suitable for deep cleaning.
Suction Mode
If the suction mode is selected, the appliance will vacuum water only and
the brush roller will not be dampened. No water is coming out of the Clean
Water Tank.
Filling the Clean Water Tank
Press the Clean Water Tank release button and pull the tank outwards to remove it.
Remove the cover of the Clean Water Tank and fill the tank with clean water. Install the
Clean Water Tank and ensure it clicks into place.
Note:
• For better cleaning performance, it is recommended to add 10ml detergent with the bottle cap
into the full Clean Water Tank, then shake gently and evenly for use.
• Do not add any liquids other than the officially-approved cleaner. The cleaner can be available
on the official online store.
9
9
How to Use
Start Cleaning
Gently step on the brush cover and recline the appliance backwards. Press the power
switch
to start operating. Press the
mode - the suction mode according to your needs.
<140°
Note:
• Do not vacuum any foamy liquids.
• The appliance will be suspended in the upright position while running.
• The appliance is suitable for cleaning floors, marble, tiles and other hard surfaces.
• Do not recline the appliance backwards more than 140° to prevent the appliance from leaking
water.
• When the appliance is in operation, do not lift it off the ground or lay it flat. Doing so may cause
the used water to flow into the motor.
Cleaning the Used Water Tank
Press the Used Water Tank release button to take out the tank. Remove the tank cover
and pour out the used water. Close the tank cover and re-install the tank before use.
2
1
to switch among the auto mode - the ultra
3
4
EN
10
10