Husqvarna RS 7400 D Manuel D'utilisation page 40

13 imPoRTAnT ADViCe
(See Fig. 2)
• Tighten loose nuts and bolts regularly, particularly after
several hours of operation.
• Check V-Belt tension regularly. Re-tighten V-Belts as
necessary. Replace V-Belts in complete sets only.
• Remove the Diamond Blade (2E) for storage. Store
it carefully.
• Check the water spray over the Diamond Blade
(2E) periodically.
• Tighten the Diamond Blade (2E) firml on the Blade
Arbor (2C).
• Make sure the contact faces of Flanges (2B & 2F),
Diamond Blade (2E), and Blade Shaft (2I) are clean.
• Use the Emergency Stop Switch (1T) ONLY in
the case of emergency. Do not use for normal
engine stopping.
• Put the saw in STOP (1V) before turning the key to
the OFF position.
14 ACCeSSoRieS
BlADe GUARD ConVeRSion kiTS:
Use the proper size blade guard for the particular diamond
blade size being operated. Consult factory for blade
guards that are available.
15 RePAiRS
We carry out all repairs in the shortest possible time and
at the most economical prices. (See back page for our
address and phone numbers.)
16 SPARe PARTS
For quick supply of spare parts and to avoid any lost time,
it is essential to quote the data on the manufacturer's
plate fixe to the machine and the part number(s) to be
replaced with every order.
The instructions for use and spare parts found in this
document are for information only and are not binding. As
part of our product quality improvement policy, we reserve
the right to make any and all technical modifications
without prior notice.
The manufacturer accepts no respon-
sibility caused by unsuitable use
or modifications.
40