Publicité
Les langues disponibles
Les langues disponibles
RBC-EP1000-CA
SET Button
Press this button to adjust the sensitivity of the bill counter sensors "+" button when in SET
mode, press "+" once to add :1" If you keep pressing this button continuously, the parameter
number will be added continuously "-" button when in set mode, press "-" once to reduce by "1".
If you keep pressing continuously, the parameter number will be reduced continuously.
Auto Button
The bill counter is preset to automatically start counting bills once placed into the hopper.
MNL Button
To change to manual start mode, press the "MNL" button, insert the bills into the hopper, and
press the "START" button.
BATCH Button
To count bills in batches, press the "BATCH" button. Batching is preset to 100 bills. To change
the batch amount, use the keypad to enter a batch number between 1 and 999.
• Press the "BATCH" button once in to set the amount to 100.
• Press the "BATCH" button twice to set the amount to 50.
• Press the "BATCH" button three times to set the amount to 20.
• Press the "BATCH" button four times to set the amount to 10.
• Press the "BATCH" button five times to cancel Batch function
You can also customize the batch quantity by using the keypad For example, if you wish to
batch in quantities of 30, simply press Batch, followed on the keypad by pressing "3",
followed by "0" (Enter 30). The number 30 will be displayed on the control panel. Press the
Start Button to confirm setting.
-9-
Publicité
