Tennant S7 EMEA Manuel D'instructions page 18

SERIAL NUMBER LABEL LOCATION
Make sure that the machine is equipped with a rating plate showing
case, notify the dealer immediately.
INTRODUCTION
This instruction manual contains guidelines and practical
information concerning the
maintenance of the machine. The machine has been designed
Before delivery, the machine has been checked at our factory
and by our dealer to guarantee that it is handed over to you in
perfect working order. To maintain the machine in this condition
and ensure problem-free operation, strictly follow the routine
maintenance instructions given in the manual.
UNPACKING
Unpack the machine with care, avoiding any manoeuvres that
may damage it; once unpacked, check that all of the parts are
intact. If you notice any damage, DO NOT use the machine and
contact your dealer. Due to packaging and transport requirements,
some parts and optionals may be supplied separately; for correct
assembly, follow the instructions given in the corresponding
paragraphs of this booklet.
Contents of the packaging:
1 Machine
1 Side brush
1 Instruction booklet
1 Declaration of conformity
1 Tool kit:
2 Ignition keys
1 Battery
If you notice that any of the above are missing, contact the dealer
immediately.
Make sure the packaging materials (bags, boxes, pallets, hooks,
etc.) are put away, out of the reach of children.
To avoid losing them during transport, the ignition
NOTES
keys are placed inside the document envelope.
EN
FIG. 1
safety, use, adjustment
PREPARING THE MACHINE
Fitting the side brush
• Move the brush raising lever (pos. 1 Fig. 3) to the "0" position.
• Unscrew the screw on the side brush shaft.
• Place the brush on the shaft (Fig. 2).
• Tighten the screw complete with washer.
and
Fitting the handle
•
• Lift the handle to the operating position (pos. 1 Fig. 2/A).
•
supplied with the machine).
- 5 -
TRANSLATION OF ORIGINAL INSTRUCTIONS
Fig. 2
2 1
Fig. 2/A