Mounting The Units; Power On - SKF TKBA 10 Mode D'emploi

4. Mounting the units

The TKBA 10 and TKBA 20 are equipped with a powerful magnet bracket
assembly, allowing the operator to mount the system on almost any
pulley face.
Mount the units on the pulley faces to be aligned.
• The reflector unit should be mounted onto the pulley to be moved
or adjusted.
• The transmitter unit should be mounted on the stationary pulley.
The user must determine which pulley is movable and which is stationary.
The movable pulley is often the smallest one, and is often mounted on the
motor shaft. In some cases both pulleys and shafts may need to be adjusted
to achieve the desired alignment.
For non-ferrous pulleys or sprocket, it is possible to use a small bar clamp
(G clamp).
Figure 4 Units mounted on pulleys

5. Power on

To turn the laser line on, use the rocker switch located on the side of the
transmitter unit.
SKF TKBA 10 & 20 9