Publicité
Les langues disponibles
Les langues disponibles
Once a mouth (twice if the stove works more than 10 hours per day) remove the
rightside panel (panel is fixed by magnet, so you just need to push it) and then remove
the small panel that is shown in the picture above and vacuum all the ashes inside the
chamber. Then put the panels back again. Also check the cleaning "T".
CLEANING THE CONVECTION BLOWER
To clean the convention blower, Disconnect the stove power cord from the electrical outlet.
Remove the side panels and rear panel (For all models). A vacuum can be used to remove any
dust accumulation on the blower's blades or inside the blower duct. Caution should be used
not to damage the blower's blades during cleaning.
CLEANING THE VENT PIPE
Soot and Fly ash: Formation and Need for Removal
The products of combustion will contain small particles of fly ash will collect in the exhaust
venting system and restrict the flow of the flue gases. Incomplete combustion, such as occurs
during start up, shutdown, or incorrect operation of the room heater will lead to some soot
formation which will collect in the exhaust venting system. The exhaust venting system
should be inspected at least once every year to determine if cleaning is necessary. Sweep the
72
Publicité
