Delba DB-870-10CZ Mode D'emploi page 58

Note: If, for some reason, the ignition phase fails and the equipment does
not ignite the pellets, error message E2 will appear after 20 minutes.
Before restarting the equipment, please remove the pellets from the
burner, vacuum the equipment well and clear the error message from the
display by pressing the key
After carrying out these operations, switch the device on again.
CHANGE POWER
As soon as the equipment
the heating
power by pressing the key . The stove has 4 power levels, P1 is the maximum and P4
the minimum.
LOW POWER P4
for 4 seconds (until you hear a beep).
enters the stabilization phase, you can change
LOW AVERAGE POWER P3
58