Publicité
Les langues disponibles
Les langues disponibles
Menu
To enter the menu, press the key
beep).
The first parameter that will appear is the adjustment of the fans for the four
power levels.
In this parameter, you can configure the speeds of the gas extractor (S) and the
hot air fan (F).
The extractor speed will depend on the type of installation, brand of pellets and
the burning of the machine, so it must be adjusted while the equipment is in
operation.
If the glass turns black after a few minutes of the machine being on or starts to
accumulate too many pellets in the burner, it is a sign that the extractor needs
more speed, so you have to increase the value of S which by default comes to 0
by default.
If the flame is very strong, the pellets are constantly jumping from the burner
and the flame starts to want to go out, this is a sign that the extractor is too strong
and needs to be reduced.
Attention, at power 4 (minimum) the flame is very small, it barely comes out of
the cup.
To change to parameter F, just press the key
for 4 seconds (until you hear the
.
61
Publicité
