Publicité
Les langues disponibles
Les langues disponibles
7. Display and control unit state
7.1 Normal functioning:
Standby - Gate closed or after the switch on of the control unit
Opening phase
Closing phase
Gate closed by user during opening
Gate closed by user during closing
Gate stopped by an external event (photocells, stop)
Gate opened without automatic reclosing
Gate opened in partial opening position without automatic reclosing
Gate opened waiting for auto reclosing, last 10 seconds the dash will be replaced by the countdown
Gate opened in partial opening position waiting for auto reclosing, last 10 seconds the dash will be replaced by the countdown
..
During the normal functioning and out from any menu, the pression of the DOWN[-] button lets you see the number of cycles
done, you will see units with dots on the bottom of display and thousand without dot, another pression of DOWN[-] or MENU
button let you to leave the cycles visualization
Visualized during the learning of transmitters
Visualized when memorized a new transmitter or at the and of a reset
Visualized when memorized a key of a transmitter already memorized
Visualized when a trasmitter is erased
Visualized during the learnign of strokes to indicate that the control unit is opening the gate and waiting for the command of
opening mechanical stop
Visualized during the learning of strokes to indicate that the control unit is clkosign the gate and waiting for the command of
closing mechanical stop
Visualized during the learning of strokes if there is an intervention of safety devices
Visualized when the control unit waits a transmitter signal, during the function of viewing of the memory
Visualized when the transmitter is not stored on the memory, during the function of viewing of the memory location.
Visualized when the control unit exits from the function of viewing of the memory location for inactivity.
Visualized during the first coupling with the Bluetooth device.
Visualized when the control unit is connected to a Bluetooth device
Visualized when Bluetooth device is disconnecting from the control unit.
7.2 Errors:
Impact sensor intervention
Safety edge intervention
Limit switches error (both opening and closing electrical limit switches busy in the same time)
Malfunctioning of photocells
Thermical intervention to preserve the control unit
Memory error
Full memory
Memory error during functions viewing memory location or cancellation of a single transmitter
The visualization of an error on the display persist until another command is given
6-1622189
rev.8
12/09/2022
ITA
ENG
FRA
ESP
DEU
POR
location.
11 / 12
Publicité
