11 USER MENU
To access the USER menu, press the key in (Fig.7). Once the key has been pressed, you must insert the password to access the various menus; to access the user menu, the
password is 000 (displayed by default). To modify the value of the passwords, use the arrow keys. When you have inserted the correct password, press the key in (Fig.7). The
monitor will show the index of the USER parameter and a 3-character string that identifies it; the string will be displayed for one second, after which it is replaced by the value
of the parameter itself. To move on to the next parameter, use the arrow keys (Fig.8). To modify a parameter, just select it, press the key in (Fig.7), modify the assigned value
using the arrow keys in (Fig.8), and confirm the modification by pressing the key in (Fig.7) again.
PASSWORD = 000
Fig. 7
Fig. 8
SETTING OPERATIONAL PARAMETERS (USER LEVEL)
Key:
: Parameter ONLY visible on units suitable for production of hot water
: Parameter visible ONLY on units suitable for the production of DHW
: Parameter ONLY visible on units with condensation control device on board
: Parameter ONLY visible on units fitted with twin compressor
: Parameter ONLY visible on units fitted with inverter compressor
Index - String
MIN value
0 StA
0
38
Setting of operational mode (HOT/COLD)
MAX value
This parameter identifies the functioning mode set for the unit:
- Set value = 0 - Cooling mode;
1
- Set value = 1 - Heating mode;
In cooling only units, this parameter is displayed but it cannot be modified.
In software versions prior to 3.75, to make the season change the unit must be in standby.
Parameter function
22/10 – 6343841_04