2
FEATURES OF ELECTRONIC REGULATION
The command panel of the unit allows the rapid setting of the working parameters of the machine, and their visualisation. The display consists of 4 figures and various LEDs
for indicating the type of operational mode, the visualisation of the parameters set and of any alarms triggered. The card stores all the default settings and any modifications.
With the installation of the PR3 remote panel accessory, it is possible to control the switching on and off from a distance, as well as the setting of the operational mode (cool-
ing-heating), and the visualisation of the alarm summary. VMF adding the accessory, the unit can be managed in a VMF, or be managed via a BMS via Modbus protocol. After
the absence of voltage for any period of time, the unit is able to start up again automatically, maintaining the original settings.
After the absence of voltage for any period of time, the unit is able to start up again automatically, maintaining the original settings.
Table of contents
1
2
3
4
5
6
ATTENTION: If you wish to implement a BMS management system, a manual is available on our site www.aermec.com with all specifications necessary for the reali-
sation of a serial supervision system.
22/10 – 6343841_04
5
ModBUS
Moducontrol Board
Command interface on the machine
Board for probes, valves and communication management with inverter module
Board for inverter compressor management
Simplified remote panel
ModBus protocol interface board
2
Modu 485BL
6
4
Element
1
3
Note
Present on ANLI units only
Present on ANLI units only
Accessory PR3
Accessory MODU-485BL
31