Switching Off And Retracting The Power Cable - Dirt Devil SWIFFY Mode D'emploi

Swiffy_de.book Seite 24 Samstag, 3. September 2005 2:41 14
3 Operating

Switching off and retracting the power cable

1
2
2
1
1
1
3.2 Switching off and
retracting the power
cable
2
1
1. Push on the desired nozzle,
nozzles (accessories)".
2. Pull the cable, by holding the plug, until the yellow mark
is reached (Fig. 6/1).
WARNING:
If the red mark (Fig. 6/2) is visible, then retract the cable
again until it is no longer visible,
"Switching off and retracting the power cable". Otherwise
Fig.6
the cable can break off. There is a risk of electric shock.
3. Switch on the cylinder vacuum cleaner using the on/off
switch (Fig. 7/1).
4. Turn on the suction using the suction controller
(Fig. 7/2).
5. Adjust the carpet/hard floor switch (Fig. 8/1) in
accordance with your type of flooring:
Fig.7
- Hard floors (Fig. 8/1)
Laminate flooring, tiles, PVC flooring, etc.
- Carpet (Fig. 8/2)
2
Long and short fibre carpets, runners, etc.
6. To vacuum, pull the cylinder vacuum cleaner behind
you like a sledge. When vacuuming, observe the
corresponding
manufacturer.
Fig.8
.
NOTE:
You can quickly reduce the suction power with the
secondary air controller (Fig. 9/1) , e.g. to release
curtains that have been sucked in.
Fig.9
1. Switch off the cylinder vacuum cleaner using the on/off
switch (Fig. 10/1) and pull the plug out of the socket.
2. Take the plug in your hand and hold it firmly.
WARNING:
The power cable can whip around when being pulled in,
it can also trip you or somebody else up or knock down
objects.
3. Press the cable retract button (Fig. 10/2) to pull in the
power cable. Guide the last part with the plug by hand.
Fig.10
Chapter 2.3, "Using other
Chapter 3.2,
recommendations of the flooring
24