Publicité
Les langues disponibles
Les langues disponibles
How to Use
EN
Fill the Clean Water Tank
1. Press the clean water tank release
button and pull the tank outward to
remove it.
3. Tightly close the tank cover after the
water has been added.
10
2. Open the tank cover and add enough
clean water to the clean water tank.
4. Install the clean water tank into the
main body until you hear a click.
咔哒
Click
How to Use
Start Cleaning
The vacuum is equipped with an upright/tilt switch. Please use it at an angle after
turning it on.
Short press the
to power on and the vacuum starts cleaning. Press
working.
Note: When the vacuum is working, do not lift it up and down or move it, and do not
tilt the vacuum to one side or lay it flat to protect against the dirty water back into the
vacuum.
＜140°
Do not recline the vacuum more than 140° to protect against water leakage.
Switch Suction Level
The vacuum is powered on by default in Standard mode. You can press the suction level
button to enter the Turbo mode according to actual needs.
again to stop
＜40°
EN
11
Publicité
