Dreame H11 Manuel D'utilisation page 11

Care & Maintenance
EN
Clean the Filter
* It is recommended to clean it after each use and replace it
every 3 to 6 months.
1. Remove the filter from the top of the
dirty water tank.
Clean the Tube
Remove the dirty water tank, wipe it with a damp cloth to clean up the dirt in the tube
before use.
16
2. Rinse the filter with clean water.
Thoroughly dry it before re-installing it.
FAQ
Error Possible Cause
The handle assembly has not
been installed in place.
The vacuum is out of battery or
low on power.
The vacuum is upright.
The vacuum
does not work. The roller brush has not been
installed in place, or the roller
brush is stuck.
The dirty water tank has not
been installed in place.
The dirty water tank is full.
The filter is clogged.
The roller brush cover, filter,
and clean water tank have not
been installed in place.
Weak suction
force.
The roller brush is entangled
by hairs.
There are some foreign objects
in the tube or the tube is
blocked.
Too much dirty water in the
dirty water tank.
The motor
is making a
strange noise.
The main suction opening is
blocked.
The power adapter is not
plugged into the electrical
The battery
outlet.
status indicator
does not light up
The power adapter is not
while charging.
connected to the charging
base properly.
EN
Solution
Reinstall the handle
assembly.
Fully charge the vacuum,
then continue to use it.
Recline the vacuum.
Reinstall or clean the roller
brush.
Reinstall the dirty water
tank.
Empty the dirty water tank.
Clean the filter.
Make sure the parts have
been installed in place
before use.
Refer to the maintenance
manual [Clean the Roller
Brush] section.
Clean the tube.
Empty the dirty water tank.
Clear any blockage in the
main suction opening.
Make sure the power
adapter is plugged in
properly.
Make sure they are
connected properly.
17