Publicité
Les langues disponibles
Les langues disponibles
Installation
EN
Charging Base Installation
Install the accessory holder into the charging base as indicated.
Vacuum Installation Diagram
Insert the end of the handle assembly vertically into the port on the top of the vacuum
as indicated, you will feel it click in place.
Note: To disassemble the handle, please use a hard object to reach into the hole on
the back of the vacuum to press the contacts, and at the same time pull the handle
upwards.
咔哒
Click
8
Charging
Note: Fully charge the vacuum before using it for the first time.
1. Place the charging base on the level ground against a wall. Connect one end of the
2. Place the vacuum on the charging base, the
2
1
Note: No operation for 15 minutes after being fully charged, the vacuum begins
sleeping.
power adapter to the charging base and another end to a home socket.
charging status. The number on the display screen represents the current battery
level in a percentage during charging. When the number is at 100, the battery is fully
charged. Once the vacuum is fully charged, the indicator will turn off after 10 seconds.
on the screen lights up to indicate the
EN
9
Publicité
