Beko TS1 90020 Manuel D'utilisation page 16

4 Preparation
Your refrigerator should be installed at
least 30 cm away from heat sources such
as hobs, ovens, central heater and stoves
and at least 5 cm away from electrical
ovens and should not be located under
direct sunlight.
The ambient temperature of the room
where you install your refrigerator
should at least be 10°C. Operating your
refrigerator under cooler conditions is
not recommended with regard to its
efficiency.
Please make sure that the interior of your
refrigerator is cleaned thoroughly.
If two refrigerators are to be installed side
by side, there should be at least 2 cm
distance between them.
When you operate your refrigerator for
the first time, please observe the following
instructions during the initial six hours.
The door should not be opened
frequently.
It must be operated empty without any
food in it.
Do not unplug your refrigerator. If a power
failure occurs out of your control, please
see the warnings in the "Recommended
solutions for the problems" section.
Original packaging and foam materials
should be kept for future transportations
or moving.
The baskets/drawers that are provided
with the chill compartment must always
be in use for low energy consumption
and for better storage conditions.
Food contact with the temperature
sensor in the freezer compartment may
increase energy consumption of the
appliance. Thus any contact with the
sensor(s) must be avoided.
In some models, the instrument panel
automatically turns off 5 minutes after
the door has closed. It will be reactivated
when the door has opened or pressed on
any key.
Due to temperature change as a result of
opening/closing the product door during
operation, condensation on the door/
body shelves and the glass containers is
normal
15
EN