SATO M-84Se Serie Manuel D'utilisation page 51

Manuel d'Utilisation
13 Vers l'Ordina-
teur
14 Référence
NOTE: The signals on pins 1, 3 4 and 6 each have an open
collector output. These pins normally measure
+.07V maximum when a true condition exists. If a
false condition occurs, the voltage will drop to 0V. To
achieve a signal level of +5V, you must add a 1K ohm,
¼ W pull-up resistor between the open collector out-
put pin and Vcc (pin 13) as illustrated. This will pro-
vide a signal level of +5V for a true condition and 0V
when a false condition exists. The maximum voltage
that can be applied to these pins is +50V and the
maximum current they can sink is 500 milliamps.
Imprimantes M-84
Vcc - +5V
Terre de Protection
Se
4. Connexions
45