Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
GENERAL RULES OF SAFETY
The planning and production of the devices that form the control
units for doors UST2, and the instructions in these instructions
for use are perfectly compliant with the current safety standards.
Nevertheless, an incorrect installation can cause serious injury to the
persons that work on the plant or that use it. For this reason, during
installation it is important to follow all the instructions for use in this
manual.
Do not start installation if you have any doubts of any kind
and, if necessary, contact the Nice Assistance Service.
WORK IN SAFE CONDITIONS!
ATTENTION! – It is important to follow these instructions for
reasons of safety.
ATTENTION! – Carefully preserve the instructions for safety
purposes.
Strictly follow these instructions.
– Make only the electrical connections described in this
manual for use: incorrect wiring can cause serious damage
to the plant.
– In the case of use outdoors, the power supply cable supplied
must be completely protected with a special protection
pipe.
In view of the risks associated with the installation and with
sy stem control, it is necessary to install the product in the
packaging, following these instructions.
– Execute only the modifications described in these instructions for
use. Any other modification can cause serious mal functio ning. The
manufacturer declines all responsibility for any damages caused
by arbitrary modifications introduced to the devices.
– Do not position the devices near sources of heat or unprotected
flames. This can cause malfunctioning, fire and other dangers.
– During installation the devices should not be immersed in water or
other fluids. Prevent the infiltration of fluids in the devices during
installation.
– The packaging material must be disposed of in strict observance
of current regulations.
ATTENTION!! – Preserve this manual with utmost care to make
device disposal or maintenance operations easier in the future.
KNOWLEDGE OF THE SYSTEM AND
PREPARATION FOR INSTALLATION
Description and use
UST2 is a control unit for rolling shutters and sectional doors with
three-phase motors in deadman mode.
Just press the special button installed on the cover or the outside
button to open or close a door.
Any other use is considered improper! The manufacturer
declines all responsibility whatsoever for damages caused
by improper use of the various system devices not compliant
with what is indicated in these instructions for use .
The plant manufacturer is responsible for the complete plant. He must
fulfil the current regulations and directives (e.g. DIN 1986, EN 12050).
He is responsible for drawing up the technical documentation of the
entire plant to be supplied together with the plant.
It is necessary to comply with the provisions and national
and local regulations regarding installation, as well as the
accident prevention rules in force.
Disconnect the system from the electrical power supply
during works.
Checks before installation
Carefully read these assembly and use instructions before beginning
installation of the control unit.
The manufacturer declines all responsibility and obligation of
warranty if any arbitrary changes in construction are made without
previous written authorisation or installation not compliant with the
assembly instructions is executed.
The plant manufacturer must ensure that the ECM directives,
low voltage directives, machinery directives and directives on
construction products are observed.
ATTENTION!
This control unit cannot be used in areas at risk of explosion.
ATTENTION!
Connect the power supply cable to terminal X1 (L1, L2, L3) and to
the PE terminal of the main board.
The power supply cable must be protected on-site with 3 x 10 HV
fuses.
The fuse must have a value such that the gearmotor makes the fuse
trip if it becomes blocked.
English – 3
Publicité
Table des Matières
