Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. PUTTING INTO SERVICES
Breakdown Maintenance
7. ADDING OIL
After long time and continuous operation, the insert nut deformation might be not
sufficient with maximum stroke, then oil shall be added as follows:
Disconnect the tool from the air supply.
1)
Keep the tool upright in stable position during all operations. Unscrew the seal
2)
screw (Item 15) and the seal (Item 14) with 4mm Allen key.
Fill the syringe (included) with hydraulic oil, screw the filled syringe up to the hole,
3)
then slowly inject the oil into the tool, adequate oil has been added as soon as
resistance is sensed, the excess oil will flow back when you release the syringe.
Unscrew and remove the syringe from the body, put the seal back and screw the
4)
seal screw tight.
Wipe off the excess oil.
5)
Warning: If you should accidentally spill oil on your skin, wash and rinse
thoroughly with water and alkaline soap.
If the insert nut blocked on the mandrel, and it can not screw
off from the mandrel by the motor. Please disconnect the tool
from the air supply, and put the stroke regulation pin into the
right hole of the spindle and unscrew the nut off with hand.
www.degometal.com
20
Publicité
Table des Matières
