Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. AIR SUPPLY
●
The tool is operated with compressed air between 3-7KGF/CM2 (45-105PSI). We
recommend the use of pressure regulators and automatic oiling/filtering systems on
the main air supply. These should be fitted within 3 meters of the tool to ensure
maximum tool life and minimum tool maintenance.
●
The air supply pipes used must have a suitable pressure resistance. Air hoses
should be oil resistant, have an abrasion resistant exterior and should be armoured
where operating conditions may result in hoses being damaged. All air hoses MUST
have a minimum bore diameter of 6.4mm or 1/4 inch.
●
An air filter is needed to remove contaminates and moisture that are contained in
compressed air, or the tool might not work well caused the rusty motor and foreign
materials in the compressed air.
www.degometal.com
16
Publicité
Table des Matières
