Function And Response Table - Petsafe PIF17-13478 Manuel D'utilisation Et De Dressage

To Set the Static Stimulation Level
Read all the steps below before attempting to set the Static Stimulation Level. Refer to the Function and Response
Table below for advice on setting the Static Stimulation Level that best suits your pet.
1. Press the Mode Button and release (3B) when the Receiver Indicator Light illuminates Red (3C).
2. The Receiver Indicator Light will emit a series of Red flashes representing the Static Stimulation Level.
3. Increase the Static Stimulation Level by pressing and releasing the Mode Button within 5 seconds of the
previous series of flashes.
The Static Stimulation levels increase in strength from 1 to 6. Pushing the Stimulation Level Button while the
Receiver Collar is on level 6 will cause the Receiver Collar to revert to level 1.
Static
Indicator Light
Stimulation
response
Level
1 Red Flash
2 Red Flashes
3 Red Flashes
4 Red Flashes
5 Red Flashes
6 Red Flashes
Over Stimulation Protection
If your pet enters the Boundary Zone or continues anywhere beyond the Pet Area, this feature limits the Static
Stimulation duration to 15 seconds. While the system locks out further Static Simulation, the green light will remain
on for 10 seconds.
In the unlikely event that your pet leaves the Pet Area, he will not receive a Static Stimulation upon return to the
Pet Area.

Function and response Table

receiver Collar Function
1 No Static Stimulation, Tone Only
2 Low Static Stimulation
3 Medium-Low Static Stimulation
4 Medium Static Stimulation
5 Medium-High Static Stimulation
6 High Static Stimulation
www.petsafe.net
Temperament of Pet
Initial Training Mode
Timid
Timid or Average
Average Energy
Average or High Energy
High Energy
11