Function And Response Table; Fit The Receiver Collar - Petsafe In-Ground Fence Manuel D'utilisation

Function and Response Table

Indicator Light
Response
1 Flash
2 Flashes
3 Flashes
4 Flashes
5 Flashes
Flashes once every
4-5 seconds
Note: Begin training with Mode 3 and only increase if your pet does not respond to the Static Correction.
____________________________________________________

Fit the Receiver Collar

Important: The proper fit and placement of your Receiver Collar is important for
effective training. The Contact Points must have direct contact with your pet's skin on
the underside of his neck.
To ensure a proper fit, please follow these steps:
1. Make sure that the battery is not installed in the Receiver Collar.
2. Start with your pet standing comfortably (2A).
3. Centre the Contact Points underneath your pet's neck, touching the skin. If
your pet has a long or thick coat, use the enclosed long Contact Points to
reach through the hair. Note: It is sometimes necessary to trim the hair around
the Contact Points to make sure that contact is consistent.
4. Check the tightness of the Receiver Collar by
inserting one finger between the end of a Contact
Point and your pet's neck. The fit should be snug but
not constricting (2B).
5. Allow your pet to wear the collar for several minutes,
then re-check the fit. Check the fit again as your pet
becomes more comfortable with the Receiver Collar.
Mode Receiver Collar Function
1 Tone and Vibration
2 Tone, Vibration and Static
Correction (Low)
3 Tone and Static Correction
(Medium)
4 Tone and Static Correction
(High)
5 Tone only
Low
Battery
www.petsafe.net
Temperament of Pet
Timid
Timid or Average
Average
Average or High Energy
Timid
2B
2A
5