Troubleshooting - Petsafe PIF17-13478 Manuel D'utilisation Et De Dressage

Why does my receiver Collar have a
beep only mode?
What if my Transmitter alarm
is sounding?
The Transmitter is beeping
intermittently when I unplug the
Power adapter from the wall outlet.
The Transmitter is generating a loud
continuous tone.
The receiver Collar is not
beeping when setting up
the Boundary Zone.
The receiver Collar is not
beeping or administering
a Static Stimulation.
The receiver Collar is
beeping everywhere.
• The beep only mode can be used in training your pet to his
boundary or for well-trained pets that no longer require
Static Stimulation.
• A beeping tone indicates power cut. If the Transmitter fails
to transmit a proper signal, a continuous alarm will sound.
Contact the Customer Care Centre or visit our website at
www.petsafe.net.
• The Power Cut Alarm in the Transmitter is activated to alert you
that power has been removed from the Transmitter and your
pet is no longer being contained. To turn off the Power Cut
Alarm, unplug the Power Adapter from the Power Jack located
on the bottom of the Transmitter or press the Alarm Disable
Button for 5 seconds then release.
• The Transmitter has a built in Transmission Failure Alarm
that continuously monitors the Transmitter output. If a
transmission failure ever occurs the alarm warns you
that your pet is no longer being contained. Contact
the Customer Care Centre or visit our website at
www.petsafe.net for a replacement Transmitter.

Troubleshooting

• Make sure Receiver Collar is turned on and Battery Status Lights are flashing
every 4 to 5 seconds.
• Charge Receiver Collar.
• The beep may be difficult to hear in a noisy environment.
• Install the Test Light as explained in the "Test Light Instructions" section, and
use it to determine the location of Boundary Zone.
• Check that the Transmitter is set up according to directions.
• Make sure Receiver Collar is turned on and Battery Status Lights are flashing
every 4 to 5 seconds.
• Charge Receiver Collar.
• Check that the Transmitter is plugged into a working standard AC outlet,
the Power Light is on, and the Transmitter controls are set at your
desired settings.
• Check that the Transmitter is plugged into a working standard AC outlet,
the Power Light is on, and the Transmitter controls are set at your
desired settings.
• Bring Receiver Collar within 3 m of the Transmitter to reset.
• Make sure no continuous alarm is sounding on the Transmitter.
www.petsafe.net 23