To Set the Static Stimulation Level
Read all the steps below before attempting to set the Static Stimulation Level. Refer to the Function and Response
Table below for advice on setting the Static Stimulation Level that best suits your pet.
1. Press the Mode Button and release (3B) when the Receiver Indicator Light illuminates Red (3C).
2. The Receiver Indicator Light will emit a series of Red flashes representing the Static Stimulation Level.
3. Increase the Static Stimulation Level by pressing and releasing the Mode Button within 5 seconds of the
previous series of flashes.
The Static Stimulation levels increase in strength from 1 to 6. Pushing the Stimulation Level Button while the Receiver
Collar is on level 6 will cause the Receiver Collar to revert to level 1.
Indicator Light Response
1 Red Flash
2 Red Flashes
3 Red Flashes
4 Red Flashes
5 Red Flashes
6 Red Flashes
Over Stimulation Protection
If your pet enters the Boundary Zone or continues anywhere beyond the Pet Area, this feature limits the Static
Stimulation duration to 15 seconds. While the system locks out further Static Simulation, the green light will remain
on for 10 seconds.
In the unlikely event that your pet leaves the Pet Area, he will not receive a Static Stimulation upon return to the
Pet Area.
12
Function and Response Table
Static Stimulation Level
1
2
3
4
5
6
petsafe.com
Receiver Collar Function
No Static Stimulation, Tone Only
Low Static Stimulation
Medium-Low Static Stimulation
Medium Static Stimulation
Medium-High Static Stimulation
High Static Stimulation