Accessories; In Case Of Problems - babymoov Simply Care Notice D'utilisation

B / Receiver
• Set the power ON/OFF switch (9) to ON position to turn on the unit. The power on indicator (7) will light
up green.
• Select the same channel as the emitter using knob (10).
• Place the receiver at a reasonable distance away from the transmitter to avoid feedback. Too close a distance
will create a screeching sound.
• Once the unit receives a signal from the transmitter, the LED of the visual level meter (11) light up. The louder
the baby's voice, the more number of LED will be lighted up.
This feature is useful in case the parents prefer to turn down
the speaker volume to keep the environment quiet while still
able to monitor the activity of baby.
• The condition of the batteries is shown by the indicator (7). When
the batteries are flat, the intensity fades and becomes red.
NB. : If you hear noises other than your baby's, change to
another channel both for the transmitter and receiver.
• For more convenience, the receiver can be carried around
using the belt clip. To remove the clip follow diagram as shown.
a. Transmitter unit
b. Receiver unit
c. User manual
Problem
• No transmission from the transmitter.
• Transmits without interruption.
• A lot of static and interference.
• Too short communication range.
10

ACCESSORIES

a

IN CASE OF PROBLEMS

Possible cause
• The batteries have run out.
• The transmitter is set in continuous
transmission mode.
The transmitter is located close to other
electrical apparatus.
• A large number of steel structures
between the transmitter and the receiver.
• The batteries have run out.
BABYPHONE SIMPLY CARE • Instruction Manual
b
• Install new batteries.
• Switch the Power/VOX/ON (2) knob to
VOX position or place the transmitter
further away from the baby
• Remove the electrical appliances away
from the source of interference or change
the channel.
• Reposition the transmitter and
the receiver.
• Replace the batteries.
c
Solution